A new type of elevated coplanar waveguide structure is described which uses airbridge technology to suspend CPW traces above a ground plane resting on a high permittivity substrate. The transmission line is effectively shielded from the substrate and is equivalent to conductor backed CPW with an extremely thin, air substrate. It is, therefore, insensitive to parasitic substrate effects such as surface waves and the effect of dielectric loss tangent. In comparison with other forms of CPW with typical lateral dimensions, the structure exhibits no high frequency roll-off at frequencies of around 240 GHz and above. Measured results show 2.5 dB/mm insertion loss at 320 GHz for a 51 Ω line. In order to demonstrate the performance of the new line at mm-wave frequencies, several passive components have been fabricated, measured and their performance compared with CPW counterparts. The experimental results, which are in close agreement with simulation results, for short and open circuited matching stubs, and band-pass and band-stop filters, clearly show improvements in terms of loss and in the characteristics of the frequency response. Also, in order to make some qualitative assessment of the variation in performance with elevation, results for elevations of 6 μm and 13 μm are compared. Low loss and a simple, MMIC compatible, fabrication process make grounded elevated CPW a promising transmission media for MMIC applications at the very high end of the millimeter-wave frequency spectrum.
2. Mei, X. B., W. Yoshida, P. H. Liu, J. Uyeda, J. Wang, W. Liu, D. Li, Y. M. Kim, M. Lange, T. P. Chin, T. Gaier, A. Fung, L. Samoska, and R. Lai, "35-nm InP HEMT SMMIC amplifier with 4.4-dB gain at 308 GHz," IEEE Electron. Device Letters, Vol. 28, No. 6, 2007.
doi:10.1109/LED.2007.896897
3. Tessmann, A., A. Leuther, H. Massler, V. Hurm, M. Kuri, M. Zink, M. Riessle, and R. Losch, "High-gain submillimeter-wave mHEMT amplifier MMICs," Microwave Symposium Digest (MTT), 1, 2010.
4. Aghamoradi, F., I. McGregor, and K. Elgaid, "Performance enhancement of millimetre-wave resonators using elevated CPW," Electron. Letters, Vol. 45, No. 25, 1326-1328, 2009.
doi:10.1049/el.2009.2348
5. Jackson, , R. W., "Considerations in the use of coplanar waveguide for millimetre-wave integrated circuits," IEEE Trans. Microwave Theory Tech., Vol. 34, 1450-1456, 1986.
doi:10.1109/TMTT.1986.1133562
6. Weller, , T. M., , L. P. B. Katehi, and G. M. Rebeiz, "High performance microshield line components," IEEE Trans. Microwave Theory Tech., Vol. 43, , 534-543, 1995.
doi:10.1109/22.372098
7. Schnieder, F., , R. Doerner, and W. Heinrich, "High impedance coplanar waveguides with low attenuation," IEEE Microwave Guided Wave Lett., Vol. 6, 117-119, 1996.
doi:10.1109/75.481085
8. Kim, , H. T., S. Jung, J. H. Park, C. W. Baek, Y. K. Kim, and Y. Kwon, "A new micromachined overlap CPW structure with low attenuation over wide impedance ranges ," IEEE Trans. Microwave Theory Tech., Vol. 49, No. 9, 2001.
9. McGregor, I., , F. Aghamoradi, and K. Elgaid, "An approximate analytical model for the quasi-static parameters of elevated CPW lines," IEEE Trans. Microwave Theory Tech., Vol. 58, 3809, 2010.
10. Ghione, , G., C. U. Naldi, and , "Co planar waveguides for MMIC applications: E®ect of upper shielding, conductor backing, finite extent ground planes, and line-to-line coupling," IEEE Trans. Microwave Theory Tech., Vol. 35, 260-267, 1987.
doi:10.1109/TMTT.1987.1133637
11. Hilberg, , W., "From approximations to exact relations for characteristic impedances," IEEE Trans. Microwave Theory Tech., Vol. 17, No. 5, 259-265, 1969.
doi:10.1109/TMTT.1969.1126946
12. Tang, , W. C. and Y. L. Chow, "CAD formulas and their inverses for microstrip, CPW and conductor-backed CPW, by successive synthetic asymptotes ," Antennas and Propagation Society International Symposium, Vol. 3, 394-397, 2001.
13. Chang, , W. H., "Analytic IC-metal-line capacitance formulas," IEEE Trans. Microwave Theory Tech., Vol. 24, 608-611, 1976.
doi:10.1109/TMTT.1976.1128917
14. Chang, , W. H., "Analytic IC-metal-line capacitance formulas," IEEE Trans. Microwave Theory Tech., Vol. 25, 712, 1977.
doi:10.1109/TMTT.1977.1129193
15. Ghione, , G., M. Goana, G. L. Madonna, G. Omegna, M. Pirola, S. Bosso, D. Frassati, and A. Perasso, "Microwave modeling and characterization of thick coplanar waveguides on oxide-coated lithium niobate substrates for electrooptical applications," IEEE Trans. Microwave Theory Tech., Vol. 47, No. 12, 2287-2293, 2002.
doi:10.1109/22.808972
16. Ghione, , G. , M. Goana, and , "Revisiting the partial-capacitance approach to the analysis of coplanar transmission lines on multilayered substrates," IEEE Trans. Microwave Theory Tech., Vol. 51, No. 9, 2007-2014, 2003.
doi:10.1109/TMTT.2003.815873
17. Cheng, , H., , J. F. Whitaker, T. M, and L. P. B. Katehi, "Terahetz-bandwidth characterzation of coplanar waveguide on dielectric membrane via time domain electro-optic sampling," IEEE MTT-S International Microwave Symposium Digest, Vol. 1, 477-480, 1994.
18. Zehentner, , J. , J. Machac, and , "Properties of CPW in the sub-mm wave range and its potential to radiate," IEEE MTT-S International Microwave Symposium Digest, Vol. 2, 1061-1064, 2000.
19. Aghamoradi, , F., I. McGregor, and K. Elgaid, "H-band elevated CPW band-pass filters on GaAs substrate," Microwave Conference (EuMC), 9-12, 2010.
Submit
