A complete energy harvesting system via Radio Frequency (RF) is designed in a broadcast station where multiple frequency sources are readily available. These frequency sources are the Intermediate Frequency (IF), 70 MHz, Wi-Fi frequency band, 2.4 GHz, and the Ku-band frequency, 13 GHz. The RF source via the Wi-Fi band (2.4GHz) is harvested via a microstrip patch antenna designed with its matching network. The harvested RF energy is transformed into usable DC power via a 8-stage Villard voltage doubler circuit. The DC power is managed by a power management system handled by the BQ25570 circuit which gives a regulated output of 3V, powers up a low power motion sensor and charges a battery at the same time. This system comes with a backup source which is the battery and able to take over the system in case the incoming RF signal fails. The RF energy harvested from the IF 70 MHz and Ku-band at 13 GHz is derived from coupler outputs which are available in broadcast stations, transmission lines, etc. Both these RF signals are converted to DC signals via a 5-stage Villard voltage doubler circuit with different matching networks. The DC power is managed by a power mux via the TPS2122 which selects the highest available power. Over the years, no works on RF harvesting have focused on smart phone charging as its application, due to the limitation in power availability. This work strives to provide enough power to charge phones and effectively gives a 5V output to charge smart phones with a charging current of 0.5A which is similar to a USB charging port.
2. Alneyadi, F., M. Alkaabi, S. Alketbi, S. Hajraf, and R. Ramzan, "2.4 GHz WLAN RF energy harvester for passive indoor sensor nodes," Proc. 2014 IEEE International Conference on Semiconductor Electronics (ICSE), 471-474, Aug. 27–29, 2014.
3. Mikeka, C. and H. Arai, "Design issues in radio frequency energy harvesting system," Sustainable Energy Harvesting Technologies — Past, Present and Future, Dec. 2011.
4. Pinuela, M., P. D. Mitcheson, and S. Lucyszyn, "Ambient RF energy harvesting in urban and semi-urban environments," IEEE Transactions on Microwave Theory and Techniques, Vol. 61, No. 7, 2715-2726, Jul. 2013.
doi:10.1109/TMTT.2013.2262687
5. Diagarajan, M. S., A. Ramasamy, N. Boopalan, and N. B. M. Din, "RF energy harvesting prototype operating on multiple frequency bands with advanced power management," Indonesian Journal of Electrical Engineering and Computer Science, Vol. 17, No. 1, 70-77, 2019.
doi:10.11591/ijeecs.v17.i1.pp70-77
6. Adami, S.-E., C. Vollaire, B. Allard, F. Costa, W. Haboubi, and L. Cirio, "Ultra-low power autonomous power management system with effective impedance matching for RF energy harvesting," 2014 8th International Conference on Proc. Integrated Power Systems (CIPS), 1-6, Feb. 25–27, 2014.
7. Diagarajan, M., A. Ramasamy, N. M. Din, and K. K. A. Devi, "Comparison on microstrip patch antenna modules and rectifier modules for RF energy harvesting," ARPN Journal of Engineering and Applied Sciences, Vol. 11, No. 10, 6228-6233, 2016.
8. Yi, J., W. Ki, and C. Tsui, "Analysis and design strategy of UHF micro-power CMOS rectifiers for micro-sensor and RFID applications," IEEE Trans. Circuits Syst., Vol. 54, No. 1, 153-166, Jan. 2007.
doi:10.1109/TCSI.2006.887974
9. Kong, N. and D. S. Ha, "Low-power design of a self-powered piezoelectric energy harvesting system with maximum power point tracking," IEEE Transactions on Power Electronics, Vol. 27, No. 5, 2298-2308, May 2012.
doi:10.1109/TPEL.2011.2172960
10. Sedeek, A., E. Tammam, and E. Hasaneen, "High efficiency 2.45 GHz low power hybrid junction rectifier for RF energy harvesting," 2018 International Japan-Africa Conference on Electronics, Communications and Computations (JAC-ECC), 147-150, Alexandria, Egypt, 2018.
11. Pulvirenti, F., A. La Scala, D. Ragonese, K. D'Souza, G. M. Tina, and S. Pennisi, "4-phase interleaved boost converter with IC controller for distributed photovoltaic systems," IEEE Transactions on Circuits and Systems I: Regular Papers, Vol. 60, No. 11, 3090-3102, Nov. 2013.
doi:10.1109/TCSI.2013.2256235
12. Devi, K. K. A., M. D. Norashidah, C. K. Chakrabarty, and S. Sadasivam, "Design of an RF-DC conversion circuit for energy harvesting," Proc. 2012 IEEE International Conference on Electronics Design, Systems and Applications (ICEDSA), 156-161, Kuala Lumpure, Nov. 5-6, 2012.
13. Diagarajan, M., A. Ramasamy, N. M. Din, and K. K. A. Devi, "Comparison on microstrip patch antenna modules and rectifier modules for rf energy harvesting," ARPN Journal of Engineering and Applied Sciences, Vol. 11, No. 10, 6228-6233, 2016.
14. Sedeek, A., E. Tammam, and E. Hasaneen, "High efficiency 2.45 GHz low power hybrid junction rectifier for RF energy harvesting," 2018 International Japan-Africa Conference on Electronics, Communications and Computations (JAC-ECC), 147-150, Alexandria, Egypt, 2018.
Submit
